As a tall-roofed family wagon, the Edge cuts through the clutter of Ford's wagon lineup nicely, with its spacious interior and spare styling for 2013, it's even better at saving gas and connecting to the outside world, though each of those choices comes with its own compromises. It was conceived of as a crossover vehicle, with all-weather duty in mind, and never has pretended to the dirty authenticity the SUV crowd demands.
2013 FORD EDGE DRIVER
PRESS the driver or passenger power door LOCK button 3 times. PRESS the driver or passenger power door UNLOCK button 3 times. PLACE the NEW un-programmed smart key in the pocket inside the center console utility compartment. Have two programmed PEPS smart keys inside the vehicle prior to beginning this procedure.
2013 FORD EDGE HOW TO
PEPS SMART KEY FOB REMOTE Step-By-Step How To Programming Instructions This indicates either no keyless entry installed on the vehicle or a defective keyless entry receiver module. Note: If your vehicle cannot enter programming mode, then you cannot program any remote. To program any additional new keys, wait 20 seconds and REPEAT this procedure.The key to be programmed must be cut prior to beginning this programming procedure.You must have 2 working transponder chip remote head keys in order to program a new remote head key without the assistance of a professional.You have a key fob remote that is compatible with your vehicle.Your vehicle is equipped with keyless entry, and.Verify the following prior to following these instructions:.If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same. Wait 20 seconds and repeat the process from Step 1. If the key was NOT successfully programmed, the theft indicator light will FLASH on and off. If the key was successfully programmed, the theft indicator light will illuminate for 3 seconds and then go out to indicate successful programming of the key. KEEP the ignition in Position 3 (RUN) for at least 6 seconds. TURN the ignition from Position 1 (LOCK/OFF) to Position 3 (RUN). Within 20 seconds of turning the ignition to Position 1 (LOCK/OFF) and removing the second key, INSERT the NEW un-programmed key into the ignition. TURN the ignition to Position 1 (LOCK/OFF) and REMOVE the second key from the ignition. Within 10 seconds of turning the ignition to Position 1 (LOCK/OFF), INSERT the second previously programmed key into the ignition. TURN the ignition to Position 1 (LOCK/OFF) and REMOVE the first key from the ignition. KEEP the ignition in Position 3 (RUN) for at least 3 seconds, but no more than 10 seconds.
INSERT the first previously programmed transponder key into the ignition. REMOTE HEAD KEY FOB Step-By-Step How To Programming InstructionsĮNTER the vehicle and CLOSE the Driver’s Door.
0 kommentar(er)
